My Vinyl Keep Tearing On My Cameo 3

If your cricut maker or cricut explore machine is tearing or dragging through the material check the following.

My vinyl keep tearing on my cameo 3.

My machine is tearing or dragging through my material there are several variables that may cause a machine to tear through material. Currently running the blade and force settings at 1 speed at 5 and still scoring the backing. The same setup on the cameo 3 but the force setting is at 10 which is their default setting for sign vinyl. My cameo will not make a clean cut on monograms.

Sometimes when the design is being cut too slow the vinyl gets stuck on the blade for a split second and is then moved out of place. If your blade raises slightly when locking into place open the lock lever and push the blade all the way down again. Got a cameo 3 and trying to figure out cutting and adding vinyl to school supplies. The vinyl sticks to the blade and peels up during the cut.

Fortunately this problem can usually be resolved with some basic troubleshooting steps. Using a cameo 3 to cut metamark m7 vinyl similar to 651. I found the sweet spot for this design at speed of 3. Hold it into place with one finger while locking the lever with your other hand.

The last few days its started to cut a bit too deep and score the backing to the point some parts tear when lifting vinyl transfer tape off. If it happens to finish the cut without tearing the vinyl the cut is not clean and the curly part of the letters comes up when weeding. I went and used a pure outline type image of wings and used the trace tool to get myself a copy and sent it to my cameo. I have bought 2 new blades in the last week.

Not using a cutting mat for longer stuff. My machine is tearing or dragging through my material older machines there are several variables that may cause a machine to tear through material. I am using silhouette vinyl. The same goes for the portrait 2 autoblade.

Go into the cut settings and change the speed to anywhere from a 1 3. But if the speed is slightly faster it doesn t have time to catch. One of the most common issues from silhouette cameo beginners is that their cameo 3 autoblade is cutting through the vinyl or other material and the backing. I use roll vinyl usually fdc 4200 vinyl no mat and on mtc i use a blade setting of 1 or 2 depending on how old the blade is and a force of around 5.

Makes a nice cut and just kiss cuts the backing paper. Slower isn t always better. You should barely see an indent in the backing. Keep doing test cuts and adjust your settings until you aren t gouging the backing.

If your cricut machine is tearing or dragging through the material check the following. On the cameo 3 and portrait 2 push in the lock lever until you see the little circle change to silhouette blue.